This key value describes the size of the tolerance window during a source power during calibration. The target stimulus power level is defined as the test port power (PowerLevel) summed with the offset value (PowerLevelOffset). When a power reading is greater than this value away from the target, the source is adjusted. The source may be adjusted for up to PowerIterationCount number of tries in attempt to reach all stimulus powers within the tolerance.

The default value is 0.05

Calibrations of the following type use this value:

This key corresponds with the PNA SCPI command "SOURce<ch>:POWer<port>:CORRection:COLLect:ITERation:NTOLerance <num>" parameter as explained the Keysight Documentation

See also: PowerIterationCount

An Example:

;******************************************************************************
;Calibration Configuration (TransmissionResponse)
;*******************************************************************************
[Cal_TransmissionResponse]
CalAcquireTimeoutSec = 60
CalSetDescription = TransmissionResponse test
CalSetName = Cal_TransmissionResponse
CalType = TransmissionResponse
ConfigType = Calibration
DirectoryToUse = c:\temp
LoadFilename = TransmissionResponseSetup.csa
SaveFilename = TransmissionResponseCal.csa
PathName = PATH_1
PowerAverageCount = 1
PowerAverageTolerance = 0.2
PowerIterationCount = 30
PowerIterationTolerance = 0.5
PowerLevel2 = 10
PowerLevelOffset = 0.0
PowerSensorPort = 1
ReceiverResponseAttenuation = 0.0
ReceiverStimulusAttenuation = 0.0
SourceAttenuation = 0.0

;******************************************************************************
;Device Configuration (DCM on PNA port 1)
;*******************************************************************************
[DCM_1]
ConfigType = Dcm
IpAddress = 10.11.201.20
IpScpiPort = 5025
IpTracePort = 5007
ResponseTimeoutSec = 60

;******************************************************************************
;Switch Configuration (DCM on PNA port 1)
;*******************************************************************************
[DCMSwitch]
ConfigType = Switch
Device = DCM_1
SwitchIndex = 1

;******************************************************************************
;Path Configuration (RF to DCM)
;*******************************************************************************
[PATH_1]
ConfigType = Path
PnaPort1Device = DCM_1:1,3
PnaPort2Device = DCM_1:3
SwitchPath = DCMSwitch:0

;*******************************************************************************
;PNA Configuration
;*******************************************************************************
[PNA_1]
ConfigType = Pna
DirectoryToUse = C:\Temp
FileTransferTimeoutSec = 60
IpAddress = 10.11.210.1
IpScpiPort = 5025
IpTracePort = 5007
PortCount = 4
ResponseTimeoutSec = 60
VerifyCommands = 0