The name of the path configuration section that defines the switch path and calibration devices to use with the calibration.

There is no default value.

All calibrations except 'ExtendWithLocalFile' are required to specify the path configuration to be used when executing the calibration.

The path specified in turn specifies the calibration devices (such as an FCM) and the PNA ports that will be used in the calibration.

See Path Config for reference.

An Example:

;*******************************************************************************
; Example configuration for a calibration type SParam using 1 port
;*******************************************************************************
[CAL_SParam_1Port]
CalAcquireTimeoutSec = 60
CalSetDescription = Cal Set for CAL_SParam_1Port calibration
CalSetName = CAL_SParam_1Port
CalType = SParam
ConfigType = Calibration
DirectoryToUse = C:\Examples
LoadFilename = Before_CAL_SParam_1Port.csa
PathName = PATH_SParam_1Port
PnaDisplayEnable = 1
SaveFilename = After_CAL_SParam_1Port.csa

; FCM calibration device definition
[FCM_1]
ConfigType = Fcm
ConnectionTimeoutSec = 1.0
FileTransferTimeoutSec = 60
IpAddress = 10.11.0.201
ResponseTimeoutSec = 60

; Path referenced by calibration defining which device will be used
[PATH_SParam_1Port]
ConfigType = Path
PnaPort1Device = FCM_1:1

; PNA definition
[PNA-X]
ConfigType = Pna
ConnectionTimeoutSec = 1.0
DirectoryToUse = C:\Temp
FileTransferTimeoutSec = 60
IpAddress = 10.11.0.200
PortCount = 4
ResponseTimeoutSec = 60
VerifyCommands = 0