The PowerBridgeToUse specifies that a power readings of a calibration will utilize a PowerBridge.and defines the power bridge configuration to be used.

There is no default value.

Calibrations of the following type that are on a dual homed system may require this value.

This key is only required on systems that are dual homed and the PNA resides on a different subnet than the calibration device and cannot communicate directly with the calibration devices with power meter capability.

For a more detailed explanation and example see PowerBridge Config.

;*******************************************************************************
; Example calibration using a Power Bridge
;*******************************************************************************
[CAL_1]
ConfigType = Calibration
CalType = SParamWithPower
PowerLevel = 10
PowerSensorPort = 1
; When this is defined power readings will be made utilizing the specified power bridge
PowerBridgeToUse = POWERBRIDGE_1